Friday, 1 April 2016

February 2016 - April 2016 (RCYC Cape Town)


Its been a while, but we have been so busy emptying the boat and doing phase 1 of our huge upgrade that there has been little time for chitter chatter.
 
Lock-up, almost full
A few people have asked what its been like transitioning from living on water to being back on land and there are definite pro’s and con’s and a number of funny things we miss, besides the obvious.  
We are fortunate enough to have a magnificent sea view from the veranda of our beachfront apartment, the sound of the waves crashing on the beach deafening at times, so whilst we don’t miss being surrounded by water, this water is different, clear, moving, alive – decidedly different to that of a marina, I’ve even seen seals body surfing in the waves.  
Thank heavens we don't have a cat, not
enough room to swing one!
Then it’s the little things like being able to walk all the way around the bed to make it, portable furniture, not having to negotiate the long walk (often at speed whilst resembling an injured duck) down the walk-on to the toilet, the insistent thunk thunk thunk of lines bashing on masts during those blustery nights when the wind is howling and the bed is rocking and rolling, a steady supply of water without needing to fill water tanks and most amazingly I miss my kitchen (galley), its decidedly bigger and more user-friendly.
I have discovered we are much more aware of electricity and water consumption on the boat – when its readily available and you’re not in charge of where it comes from complacency tends to set in, hmmm…..

The awesome view from our balcony not only provides us with fabulous sunsets behind Table Mountain, but also a birds eye view of Wednesday night sailing.  Wednesday night sailing seems to be an almost world wide phenomenon at Yacht Clubs, an event for serious and social sailors to get out on the water and do what they do best, then swop stories and banter in the bar afterward over a well earned cold one.  Every time I see them out there I am reminded of a story we were told by a lovely British couple who sailed into Royal Cape Yacht Club in December, flustered and breathless in a howling South Easter of 45 knots, their last stop before departing across the Atlantic.  They compared their arrival to that of another couple they met on their travels abroad who had arrived at a harbor in South Africa, teeth gritted, jaws clenched and eyes the size of saucers as they desperately steered their yacht into the marina at the yacht club aiming for the safe haven of a solid mooring and a bit of a respite from the unrelenting wind, when they were met, head on, by a fleet of local yachts all cheerily heading out of the harbor to take part in a Club sailing event – you South Africans are crazy was their gasping comment.  Ha ha, yes, I think we are!!


The end of February saw Chrissy and Alan on their beautiful catamaran Sundowner Rose arrive at False Bay Yacht Club, Simons Town.  Was so exciting to see them and hear their stories of their trip down the beautiful, rugged coast from Durban and of course a great excuse for champagne – they arrived around 1am, tired but smiling.
Takes heaps of concentration

Touch down
Then, finally, the day arrived and out of the water we popped.  To quote Eileen “its like the long anticipated birth of the baby, only this is more like the birth of a baby elephant it has taken so damn long to happen!!”.  Great excitement and trepidation all in one, the beginning of the final preparations for our next adventure…


Its really sad to say farewell and when yachties become friends its even more tough so perhaps “til later” and definitely “cheers” is more appropriate than goodbye.  Time came for Reece the crazy Kiwi to go and he sure did it in style, we had a farewell dinner with Craig at Wang Thai, he had a party in town at his “local” 
and we even managed Margarita’s at the airport.  
Cheers Reece, we will certainly meet again, looking forward to it – oh and boy is it quiet at the Club now!!

Getting rid of layers of anti foul paint
Two days later
A funny thing about boats is that no matter how prepared you are, they will always test you with a curve ball and Maxscene throws them like a seasoned baseball player!  
Finally its clean


Dusty work
Primer applied to outside of hulls
New anti foul applied
The hull was stripped to original fiberglass, one small area of suspicion ground out and repaired then primer and new anti-foul applied, beautiful and good to know the integrity of the hull is sound.  

Any place becomes a workshop




At the same time the chines were filled in, this is to stop the incessant slapping noise of the water and to create buoyancy and give us a bit more of that elusive speed that sailors are always looking for.  What a beautiful job was done.
Making template for closing chines


Closed chines - beautiful job

The engines are carried out on a sling
suspended from a bar
Everything padded to prevent damage
while removing engines
The engines (both old and new) had to be stripped to bare minimum to get them through the doorways of the cabins, I am sure there is a logical reason for these doorways being built so narrow, thank heavens Andrew knows what he is doing, worst jigsaw puzzle I have ever seen.  

Stripping old engine
Stripping new engine


Old engine bed in grotty bay
Pieces of old engines
Then upon examination of the engine beds it was discovered they had, after 18 years, absorbed a fair amount of diesel and would best be replaced – after a bit of a scramble Andrew managed to find a mold at Yanmar – suppliers of the motors – and he was able to build two new ones, minor delay!! 
Fibre glassing new engine beds in place
New engine bed new hole

 Also, the motors needed to be moved backward as the new ones were slightly longer and would no longer fit in the space allocated, this required fibre glassing the old hole for the sail-drive closed and cutting a new one in the correct position.  New controls fitted, new sail drives in place, through hull fittings made for water maker, engines onboard and ready to re-splash.


Making that bay look
like new again
Engine bay painted
New engine bed, beneath is the old hole

















Moved switch panel down
Refitted water intake
Servicing through hull fittings




The Easter Weekend meant Kevin finally had a few well deserved days off work, in South Africa, so we made the best possible use of them.  A visit to the market, braai’s on the balcony, sleep-ins and – yep you guessed it, work on MaXScene.  We cut out the panel above the chart table to enable dropping and hinging of the electrical panel to allow better access to the wiring behind.  
Through hull fittings back in place
Cut holes for new instruments

We will close the top with a piece of wood which will house the auxiliary chart plotter and weather station.  We also removed all the eyebrows from the port lights, they are to be replaced with new more durable fiberglass versions, but also to facilitate replacement of the 5 outstanding port lights.  
Instruments and wheel installed
We also serviced the through hull fittings and cut the holes for the new instruments.  



Right, its in

So where does this bit go?
The new engines were brought in, amid some grumbling from Andrew who was more keen on cutting us some new hatches in the roof of the rear cabins and dropping them in there, but he managed to make a miracle happen and in they went.
 
Beautiful
New Sail drive


New propellor
Over
Behind

Being a catamaran on the hard at RCYC is quite an experience, due to the shortage of space big things happen in little areas.  We were directly in the path of mono hulls that were being hauled out, some over the top of our cockpit and some a close shave behind, hair raising I tell you!!!  

Cape Doctor
We also had a first hand view of the Cape Doctor – the South Easter blows over Table Mountain, pouring clouds over – when we see this we know “its gonna blow”.  Its called the Cape Doctor as apparently this strong chilly wind blows germs and anything else in the air away.



We bade a fond farewell to our little tender boat too.  It was heavy and we have a feeling it was retaining water in the foam in the hull, making it even heavier and impossible for two of us to drag around, much less pick up.  We found a company that manufacture smaller, lighter tenders and would take ours as a trade-in, so we waved her on her merry way and await the new svelte version which we will receive once we are done renovating.


Fortunately its not all work and no play, we celebrated Valentines day in style with our first braai on our balcony with Eileen and Reece, a fun day with good food, lots of good wine and laughter.  There was also time for a Barnyard show with Tjaart and Natalya, such great entertainment.  Then drinks and catch up at Quay 4 with Liesl and Andrew who were here on a short visit to Gordons Bay.  Didn’t feel like the years its been since we last had a drink together, good times.

The Crichtons are back in town after a whirlwind trip up to Richards Bay and back, so great to have them just over the mountain, always heaps of fun.
I even managed a 4 hour photography course with Cape Photographic Company, heck of a nice chap and learned so much. 
Off her keels, finish off anti foul

And there she goes...
A scary feeling returning to the water knowing there are new holes in the boat, are they water tight? Will everything be ok? Then, as we were so pushed for time (we had overstayed our time on the hard by 2 weeks) the drive was on to be watertight, not fully functional, so while the sail drives and motors were in place and sealed, the motors were not connected so there was the additional issue of not being self propelled.  Add to that wind gusting to 25knots and we had to be pushed around to a temporary mooring close to the yard with the clubs boat.  
Not the most ideal situation.  

On her temporary mooring til we return


Be that as it may, all has gone well, no leaks, no insurmountable issues and the job done by Andrew and his crew so far has been fabulous, we are really happy with how beautiful our MaXScene looks.


So now we leave Cape Town for 2 weeks, off to Pretoria for Kylie’s 18th birthday, Samantha & Marius’ wedding and to catch up with/say farewell to family and friends – the end of the year is drawing closer and before we know it we will be heading across the oceans….

No comments:

Post a Comment

May - August 2021 – St Thomas USVI

  Firstly, Maxscene is no longer the “boat with no name”, she is now called APOTA (All Part Of The Adventure) and we are cautiously optimist...